1, the pipeline production line cleaning

Duct production line in the long process of work, will accumulate a lot of material and debris, so the duct production line need to be timely cleaning and maintenance, so as to avoid problems. Here we provide three kinds of duct production line cleaning method:

(1) gas rinse

The hose with nozzles connected to the ducts can transport compressed air, transport the compressed gas, and expel dust and dirt from the duct into the vacuum container to achieve the purpose of removing dust and debris.

(2) vacuum suction pollution

This method requires the use of a cleaning tool, called the vacuum suction museum. Vacuum suction pipe with hand-held, brush can be directly contact the inner wall of the pipeline to achieve the purpose of cleaning the stain inside the tube. However, there is a requirement for this method, that is, the duct of the duct must be large enough. In addition, because the duct can not form enough negative pressure conditions, it is likely that the use of this cleaning will miss some of the stains.

(3) power wash

The power of this way comes from the pneumatic or electric, brush in the aerodynamic or electric power under the action of brushing the dirt in the duct, and then the way the gas rinse the dirt transported to the vacuum collector, the use of this It is important to note that the surface of the insulation material is carefully destroyed during the cleaning process.

2, the daily maintenance of the duct production line

Duct production line in the daily use of the work should also pay attention to the routine maintenance work, need to pay attention to the following:

(1) often check the work of the duct production line, found that the problem should be amended in time, is strictly prohibited with the fault to run the machine to prevent the occurrence of security incidents.

(2) to keep the appearance of the duct production line clean and clean, long-term use, should be applied to the appearance of anti-rust grease.

(3) Operators should operate correctly in accordance with the specifications, and understand and master the machine performance and operating methods. It is forbidden for non-professional operation.

3, the regular maintenance of the duct production line

(1) regularly to the duct production line of the transmission teeth to add appropriate amount of lubricating oil, which can greatly reduce the degree of wear in the operation of the machine.

(2) Under normal circumstances, the duct production line maintenance cycle is six months, regularly open the machinery and equipment for inspection and maintenance.